Anything longer than that will fall into 4" or 6" Extension Tap. But if you need longer Reach then a DIN Tap is a little longer and will give you clearance in deeper holes, this is on page 2 of the pdf below. Most Taps will be ANSI, which is on page 1. If you also use a Synchro Tap Holder that gives better runout and Axial Compensation then you can run it much faster:īelow is a link to the standard tap dimensions all our ANSI and DIN Taps are manufactured to. You can run these in a standard holder and these will improve tap life. This is available in Spiral Flute and Spiral Point Cut Taps as well as Form Taps with more Lobes to reduce Tool Pressure.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |